All Issue

2023 Vol.33, Issue 3 Preview Page

Research Article

Types and Characteristics of Landslides in Danyang Geopark

단양 지질공원 내의 산사태 유형과 특징

Seong-Woo Moon1
,
Ho-Geun Kim2
,
Yong-Seok Seo3*
문 성우1
,
김 호근2
,
서 용석3*
1Post-Doctor, Department of Earth and Environmental Sciences, Chungbuk National University
2Geology Expert, Department of Environment, Danyang Country Office
3Professor, Department of Earth and Environmental Sciences, Chungbuk National University
1충북대학교 지구환경과학과 박사후연구원
2단양군청 환경과 환경연구사
3충북대학교 지구환경과학과 교수
*Corresponding Author
30 September 2023. pp. 427-438
PDF XML Citation
Abstract

We carried out a geological survey to classify the types of mass movement in Danyang Geopark (where various rock types are distributed) and analyzed the mechanical and hydraulic characteristics of landslide materials using a series of laboratory tests. Debris flows occurred in areas of limestone/marble, shale, and porphyroblastic gneiss, and limestone/marble landslides were distinguished from the others through the presence of karren topography. Soil tests showed that soil derived from weathered gneiss, which has a higher proportion of coarse grains, has a higher friction angle, lower cohesion, and larger hydraulic conductivity than soils from areas of limestone/marble, and shale. Rock failure mass movements occurred in areas of phyllite, sandstone, and conglomerate and were subdivided into plane failure, block-fall, and boulder-fall types in areas of phyllite, sandstone, and conglomerate, respectively. The shear strength of phyllite is much lower than that of the other types of rock, which have similar rock quality. The slake durability index of the conglomerate is similar to that of the other rock types, which have similar degrees of weathering, but differential weathering of the matrix and clasts was clearly observed when comparing the samples before and after the test. This study can help establish appropriate reinforcement and disaster prevention measures, which depend on the type of mass movement expected given the geological characteristics of an area.

Keywords
Danyang geopark
mass movements
rock type
debris flow
rock failure

본 연구에서는 다양한 암종이 분포하는 단양 지질공원 내에서 발생한 산사태를 대상으로 야외지질조사를 통해 유형을 분류하고, 샘플링 및 실내 시험을 통해 산사태 구성 물질의 역학적 ‧ 수리학적 특성을 분석하였다. 토석류 산사태 유형은 석회암 및 대리암, 셰일, 반상변정질 편마암 지역에서 발생하였으며, 석회암 및 대리암 지역에서는 카렌지형의 영향을 받아 암반과 암반 사이의 토사가 붕괴되는 형태로 다른 두 지역의 산사태와 구분된다. 토질시험 결과에서는 조립질 함량이 많은 편마암 풍화토가 다른 두 지역의 풍화토에 비해 내부마찰각이 높고 점착력이 작으며 투수계수가 큰 특징을 보인다. 암반 산사태 유형은 천매암, 사암, 역암 지역에서 발생하였으며, 천매암 지역에서는 평면파괴 형태가, 사암 지역에서는 부석형 낙석 형태가, 역암 지역에서는 전석형 낙석 형태가 발달하고 있다. 천매암의 전단강도는 동일한 암질의 타 암종에 비해 훨씬 낮게 나타나며, 역암의 슬레이크 내구성 지수는 타 암종과 유사하나 시험 전 ‧ 후 시료의 상태를 비교하면 기질부의 차별풍화 및 이로 인한 역의 탈락 형태가 뚜렷이 관찰된다. 본 연구의 결과는 지질특성별 산사태 유형에 따른 적절한 보강방안 및 방재대책을 수립하는데 기여할 수 있을 것으로 기대된다.

키워드
단양 지질공원
산사태
암종
토석류 유형
암반 붕괴 유형
References
1
ASTM D2216-10, 2010, Standard test methods for laboratory determination of water (moisture) content of soil and rock by mass, ASTM International, West Conshohocken, PA, DOI: 10.1520/D2216-10. 10.1520/D2216-10
2
ASTM D2487-17, 2017, Practice for classification of soils for engineering purposes (Unified Soil Classification System), ASTM International, West Conshohocken, PA, DOI: 10.1520/D2487-17. 10.1520/D2487-17
3
ASTM D3080-98, 1998, Standard test method for direct shear test of soils under consolidated drained conditions, ASTM International, West Conshohocken, PA, DOI: 10.1520/D3080-98. 10.1520/D3080-98
4
ASTM D422-63, 2007, Standard test method for particle-size analysis of soils, ASTM International, West Conshohocken, PA, DOI: 10.1520/D0422-63. 10.1520/D0422-63
5
ASTM D4644-04, 2004, Standard test method for slake durability of shales and similar weak rocks, ASTM International, West Conshohocken, PA, DOI: 10.1520/D4644-04. 10.1520/D4644-04
6
ASTM D5607-08, 2008, Standard test method for performing laboratory direct shear strength tests of rock specimens under constant normal force, ASTM International, West Conshohocken, PA, DOI: 10.1520/D5607-08. 10.1520/D5607-08
7
ASTM D854-10, 2010, Standard test methods for specific gravity of soil solids by water pycnometer, ASTM International, West Conshohocken, PA, DOI: 10.1520/D0854-10. 10.1520/D0854-10
8
Cruden, D.M., Varnes, D.J., 1996, Landslide types and processes, In: Turner, A.K., Schuster, R.L. (Eds.), Landslides: Investigation and Mitigation, Transportation Research Board, Special Report 247, 36-75.
9
Hungr, O., Evans, S.G., 2004, The occurrence and classification of massive rock slope failure, Fachzeitschrift Fuer Geomechanik und Ingenieurgeologie in Bauwesen und Bergbau, 22(2), 16-23.
10
Hutchinson, J.N., 1988, General report: Morphological and geotechnical parameters of landslides in relation to geology and hydrogeology, Proceedings of the 5th International Symposium on Landslides, Lausanne, 1, 3-35.
11
Ito, T., Matsui, T., Hong, W.P., 1982, Extended design method for multi-row stabilizing piles against landslide, Soils and Foundations, 22(1), 1-13. 10.3208/sandf1972.22.1
12
JARA (Japan Road Association), 2000, Manual for rockfall countermeasure (in Japanese).
13
Kang, Y.P., 1994, Caractéristique pédo-géomorphologique sur les phénomènes karstiques -A l'exemple de Samhwa-Dong, Danyang-Gun, Corée du Sud-, Journal of the Korean Geomorphological Association, 1(2), 85-102 (in Korean).
14
Keefer, D.K., Johnson, A.M., 1983, Earthflows: Morphology, mobilization and movement, USGS Professional Paper 1264. 10.3133/pp1264
15
Kim, H.G., Kim, T.K., Oh, K.H., 2010, Analysis of the mechanical properties and slake durability of fresh to weathered Cretaceous shale, The Journal of Engineering Geology, 20(3), 311-318 (in Korean with English abstract).
16
Kim, Y.N., Chae, Y.S., Lee, K.I., 2005, A case study of hybrid reinforced geo-structure using reinforced concrete block and slope, Journal of the Korean Geosynthetics Society, 4(4), 47-56 (in Korean with English abstract).
17
Kwan, J.S.H., Chan, S.L., Cheuk, J.C.Y., Koo, R.C.H., 2014, A case study on an open hillside landslide impacting on a flexible rockfall barrier at Jordan Valley, Hong Kong, Landslides, 11(6), 1037-1050. 10.1007/s10346-013-0461-x
18
Lee, J.I., Jung, C.G., Kim, S.H., Hwang, Y.C., Lee, S.H., 2011, A study on the evaluation of expanded metal characteristics for application rockfall facilities, Journal of the Korean Geoenvironmental Society, 12(9), 13-20 (in Korean with English abstract).
19
Matsui, T., San, K.C., 1992, Finite element slope stability analysis by shear strength reduction technique, Soils and Foundations, 32(1), 59-70. 10.3208/sandf1972.32.59
20
Naver, 2020, Photograph of naver roadview, Retrieved from https://map.naver.com/v5/?c=15,0,0,2,dh.
21
Park, J.H., Suh, J.W., Lee, S.H., Park, C.S., Park, H.D., 2014, Analysis of rock weathering characterization around fault using laboratory tests, Journal of the Korean Society of Mineral and Energy Resources Engineers, 51(5), 668-667 (in Korean with English abstract). 10.12972/ksmer.2014.51.5.668
22
Seo, Y.S., Yun, H.S., Kim, D.G., Kwon, O.I., 2016, Analysis on physical and mechanical properties of rock mass in Korea, The Journal of Engineering Geology, 26(4), 593-600 (in Korean with English abstract). 10.9720/kseg.2016.4.593
23
Takahara, T., Matsumura, K., 2008, Experimental study of the sediment trap effect of steel grid-type sabo dams, International Journal of Erosion Control Engineering, 1(2), 73-78. 10.13101/ijece.1.73
24
Varnes, D.J., 1978, Slope movement types and processes, In: Schuster, R.L., Kizek, R.J. (Eds.), Landslides: Analysis and Control, US National Academy of Sciences, Transportation Research Board, Special Report 176, 11-33.
25
Won, C.G., Lee, H.Y., 1967, Explanatory text of the geological map of Danyang (1:50,000), Geological Survey of Korea, 33p.
26
Xie, T., Yang, H., Wei, F., Gardner, J.S., Dai, Z., Xie, X., 2014, A new water-sediment separation structure for debris flow defense and its model test, Bulletin of Engineering Geology and the Environment, 73(4), 947-958. 10.1007/s10064-014-0585-9
27
Zaruba, Q., Mencl, V., 1969, Landslides and their control, Elsevier, 238p.
Information
  • Publisher :Korean Society of Engineering Geology
  • Publisher(Ko) :대한지질공학회
  • Journal Title :The Journal of Engineering Geology
  • Journal Title(Ko) :지질공학
  • Volume : 33
  • No :3
  • Pages :427-438
  • Received Date : 2023-08-31
  • Revised Date : 2023-09-11
  • Accepted Date : 2023-09-12
  • DOI :https://doi.org/10.9720/kseg.2023.3.427
Journal Informaiton The Journal of Engineering Geology The Journal of Engineering Geology
Online Submission
  • NRF
  • KOFST
  • KISTI Current Status
  • KISTI Cited-by
  • crosscheck
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close